wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 1 / 7 version 1.7 product features applications ? gan on sic broadband high power amplifier ? 10 0 0 ~ 2 00 0mhz operation bandwidth ? small signal gain 27 db min. ? 2 0w typical. @ p3db ? general purpose . description the power amplifier module is designed for broadcasting , telecommunicat ion, medical and other markets. operating frequency range is from 10 0 0 ~ 2 00 0mhz. gallium nitride on sic technology is used and attached on an aluminum sub carrier. full in/out matching for broadban d performance is already applied. improved thermal handling by patented technology. electrical specifications @ v cc = 28v; t c = 4 5 c ; z s = z l = 50? parameter u nit m in t yp m ax c ondition operating frequency mhz 10 00 - 2 00 0 - small signal gain db 27 29 31 - gain variation vs frequency dbpp - 1 2 - p 3 db dbm 4 1 4 3 - 10 0 0 ~ 12 00mhz 4 2 4 4 - 12 00 ~ 2 00 0mhz oip3 @ po = +33dbm (1mhz tone spacing, cw 2 - tone) dbm 48 50 - 100 0 ~ 160 0 mhz 46 48 - 160 0 ~ 200 0 mhz input return loss db - - 10 - 6 - output return loss db - - 1 0 - 5 - 2 nd harmonic suppr ession dbc - - 35 - 28 cw 1 - tone @po = +30dbm, freq 10 00mhz supply voltage v 27.5 28 30 vcc(=vds) quiescent current consumption a - 2.2 2.5 - current consumption @ p 3 db a - - 3.6 cw 1 - tone on/off switching time * us - 3 5 on : ttl "low" off : ttl "h igh"(3 0ma@disable) shut down or switch on/off ttl voltage ** v 0 - 0.5 on : ttl low(enable) 2.5 5 5.5 off : ttl high note. *. gate on/off : high speed switching **. drain on/off : 300ms delay package type : d p - 75
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 2 / 7 version 1.7 absolute maximum ratings parameter u nit r ating inpu t rf power dbm 20 supply voltage v 30 load mismatch value - 3 : 1 @all load phase * input signal condition : cw 1 - tone environmental characteristics parameter u nit m in t yp m ax symbol operating case temperature c - 10 - 80 tc storage temperature c - 40 - 105 tstg vibration mil - std - 810g method 514.6 annex c vi ordering information part number package rwp 1502 0 - 5 0 pallet rwp 1502 0 - 5 h * module assembled with rwp 1502 0 - 5 0 * rwp 1502 0 - 5 h is a sma connectorized housing version of rwp 1502 0 - 5 0. electri cal parameters are all same as rwp 1502 0 - 5 0. for more information, please contact rfhic mechanical specifications * dimension and weight may change without notice. parameter u nit t yp dimension package L 70(l) x 50.8(w) x 17.1(h) housing 90(l) x 75(w) x 25(h) weight package g 75 housing 270 housing rf in/out connector - sma female cooling - external heat - sink
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 3 / 7 version 1.7 typical performance @ 25 c frequen cy p1db p3db current@p1db current@p3db 2nd harm @30dbm oip3 (30dbm/tone) (mhz) (dbm) (dbm) (a) (a) (dbc) (dbm) 1000 39.4 42.5 2.3 2. 9 - 34.7 49.5 11 00 39.8 4 2.9 2.4 3.1 - 4 3.5 49.8 1 200 40.6 4 3.8 2.1 3.3 - 49.4 50.4 1 300 41.5 4 4.5 2. 5 3.3 - 47.7 5 0.8 1 40 0 42.1 4 4.5 2. 5 3.3 - 43.3 5 1.0 1 500 42.3 45. 2 2. 5 3.2 - 41.8 5 1.1 1 600 43.0 4 5.4 2. 4 3.0 - 4 3.8 51. 0 1 700 43.2 4 5.4 2.3 2.7 - 4 6.1 50.3 1 800 42.6 44 .8 2.1 2.5 - 4 9.6 4 9.5 1 900 42.4 4 4.3 2.0 2 .3 - 52.7 4 8.5 2 000 42.0 4 3.9 2.0 2.3 - 61.3 47. 6 1.5 2 2.5 3 3.5 4 4.5 5 5.5 6 6.5 40 41 42 43 44 45 46 47 48 49 50 1000 1100 1200 1300 1400 1500 1600 1700 1800 1900 2000 ids [a] pout @ p3db [dbm] frequency[ mhz ] pout & ids @ p3db vs frequency pout ids 40 41 42 43 44 45 46 47 48 49 50 1000 1100 1200 1300 1400 1500 1600 1700 1800 1900 2000 pout @ p3db [dbm] frequency[ mhz ] pout @ p3db vs temp tc= - 10?c tc=45?c tc=80?c pout @ p3db vs frequency
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 4 / 7 version 1.7 prec autions 1. this product is designed to be used for broadband amplification. heat generation is higher when there is no rf signal in the device. therefore, the worst case scenario is when there is no rf signal, and the amplifier is on with current draw. the temperature must be calculated properly. case temperature must maintain below 8 0 c . right side drawing notes how to use a temperature monitoring function to protect against overheating. 2. thermal grease or metal thermal interface materials are recommended for heat dissipation. an example would be spreading thermal grease on the bottom of the device shut down vcc(+28v) rf in rf out (+5v) switch on/off rf out temp monitor temp monitor ref voltage + - +vcc comparator block (with hysteresis gap)
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 5 / 7 version 1.7 package dimensions (type: dp - 75 ) * u nit: mm[inch] | tolerance: 0.2[.008] p in description pin no function pin no function 1 rf in 4 switch on/off 2 vcc(+28v) 5 temp monitor 3 shut down(+5v) 6 rf out * terminal pin information : ask206091,aa (acethink, pin) , ask20556,aa - 1(acethink, pin socket) * recommended screw torque : 8.0kgf.cm 1 usi ng sems m3 10mm bolt how to connected the package to a target pcb w ith pin w ithout pin
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 6 / 7 version 1.7 sma connectorized housing dimensions
wideband power amplifier rwp 15020 - 5 0 korean facilities : 82 - 31 - 250 - 5078 / rfsales@rfhic.com all specifications may change without notice us facility : 919 - 677 - 8780 / sales@rfhicusa.com 7 / 7 version 1.7 revision history part number release date version modification data sheet status rwp15020 - 50 2014.5.2 3 1.7 conditi on & g raph modification - rwp15020 - 50 2014.4.2 1.6 mechanical specifications - rwp15020 - 50 2013.10.18 1.5 parameter & g raph modification - rfhic corporation reserves the right to make changes to any products herein or to discontinue any pr oduct at any time without notice. while product specifications have been thoroughly examined for reliability, rfhic corporation strongly recommends buyers to verify that the information they are using is accurate before ordering. rfhic corporation does not assum e any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, inc luding without limitation consequential or incidental damages. rfhic products are not intended for use in life support equipment or appl ication where malfunction of the product can be expected to result in personal injury or death. buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, prot ect and hold rfhic corporation and its directo rs, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such unauthorize d use. sales, inquiries and support should be directed to the local authorized geographic distributor for r fhic cor poration. for customers in the us, please contact the us sales team at 919 - 6 77 - 8780 . for all other inquiries, please contact the international sales team at 82 - 31 - 250 - 5078.
|
